FENDT 926 Vario User Manual

207
FAULTS AND REMEDIAL ACTIONS
Fault-module
Fault-module
Fault-module
Fault-module
6. Contaminated transmission oil filter
Display accompanied by warning light.
Note: Change the cartridge as soon as the display appears. The display may go out
again, still change the cartridge.
Cause Remedial Action
Contaminated hydraulic oil filter element. Replace filter unit.
7. Excessive transmission oil temperature (95° - only in range II)
Cause
Remedial Action
Heavy traction work over extended period in
range II.
Switch to driving mode I.
Cooler soiled. Clean the transmission oil cooler.
Turboclutch function active for too long. Increase engine speed (above 1400 rpm).
Clutch pedal depressed for too long. Release clutch pedal.
8. Transmission oil temperature too high (105°)
Cause
Remedial Action
Transmission oil too hot. Allow transmission oil to cool down.
Cooler soiled. Clean the transmission oil cooler.
9. Oil level too low in brake and clutch system
Indication accompanied by intermittent audible signal and warning lamp.
Cause Remedial Action
Oil leakage. Check brake system for leaks. If necessary, fill up
with hydraulic oil (Pentosin CHF 11 S).

FENDT 926 Vario Specifications

General

Engine Power	260 hp
Transmission	Vario continuously variable transmission
Fuel Tank Capacity	500 liters
Weight	10, 500 kg
Engine type	6-cylinder turbocharged
Rated engine speed	2100 rpm
Displacement	7.5 liters
Number of cylinders	6
Maximum speed	50 km/h
Tire Options	Multiple options available