46
OPERATION
Actuating the preselected speed
Operation_Pic_number:1
Text-module
● While the tractor is moving, move the joystick
briefly to the right (away from driver seat).
Depending on preselection, indicator 1 or 2 is lit
green (see OPERATION Fig. 66).
Depending on preselection, indicator B or D is lit
green (see OPERATION Fig. 65).
Memorised selected speed is activated and re-
mains constant independent of the engine
speed.
By adjusting the stored speed with the appro-
priate rotary control, Tempomat cruise control
speed can be adjusted to operating conditions.
When operating the other memory button (OPE-
RATION Fig. 67/A,B), the cruise control adjusts
to the new target speed.
Indicator lamp (A / see OPERATION Fig. 68) is
lit, speed is indicated on the multiple display (B /
see OPERATION Fig. 68) for 3 seconds.
NOTE:
Memorised speeds can only be activated
while the tractor is moving.
The stored speed can be actuated in both dri-
ving modes and both directions of travel.
If the selected speed is not reached, check
the setting for the load limit control.
Text-module
ETNum-list
Cruise control function remains active until
one of the following occurs:
1.clutch pedal is depressed.
2.brake pedal is depressed (also individual
wheel brake).
3.joystick is activated.
4.neutral key is activated.
5.engine brake is activated.
6.engine speed falls below 1,300 rpm.
7.a driving mode is selected.
Fig.68
7.9 Load limit control
The load limit control is activated automatically if
engine speed drops under load. To do this, the
tractor automatically uses the transmission con-
trol to reduce the vehicle speed so that engine
speed does not drop any further.
Setting load limit control
Operation_Pic_number:1
● Press key (F4). The following sub-menu ap-
pears.
Operation_Pic_number:1
Text-module
The set engine load limit is displayed by the bar
indicator (C), e.g. 14 %.
● The rotary control (P1) can be used to set en-
gine load between 0 % - 30 %.
The setting is effective immediately. In this way,
the tractor can be adapted to the current situa-
tion during operation.
The load limit control only changes the transmis-
sion ratio to slower. Re-accelerating, once the
engine speed rises again, can either be done
manually using the joystick or automatically with
the cruise control function.
Fig.69
Fig.70
To Next Page
Loading...
Need help?
General
