1. Installation
1-3
Festo Festo P .BE CP FB13-E-EN en 9910c
1.1 General instructions
Warning
Before carrying out installation and maintenance work,
switch off the following:
– the compressed air supply
– the operating voltage on the field bus node (pins 1
and 2)
– the load voltage supply to the valves.
Y o u will thereby avoid:
– uncontrolled movements of loose tubing
– uncontrolled movements of the connected actuators
– undefined switching states of the electronics.
Caution
The node of the CP system contains electrostatically sensi-
tive components.
S Do not therefore touch any contacts.
S Observe the regulations for handling electrostatically
sensitive components.
Y ou will then prevent the electronics in the node from being
damaged.
General information on installing the CP modules can be
found in the manual for the “CP system”.
To Next Page
Loading...
