Contents and general safety instructions
V
Festo Festo P .BE CP FB13-E-EN en 9910c
Designated use
The CP field bus node type CP-FB13-E described in this man-
ual has been designed exclusively for use as a slave on the
PROF I BUS-DP. CP modules from Festo can be connected to CP
field bus node CP-FB13-E. The CP node may only be used as
follows:
– in accordance with designated use
– in its original state
– without any modifications by the user
– in faultless technical condition.
If additional commercially-available components such as sen-
sors and actuators are connected, the specifiedlimits for pres-
sures, temperatures, electrical data, torques, etc. must not
be exceeded.
Please observe the standards specified in the relevant
chapters and comply with technical regulations, as well as
with national and local regulations.
To Next Page
Loading...
