2. Commissioning
2-5
Festo Festo P .BE CP FB13-E-EN en 9910c
2.1.4 General information
FREEZE and SYNC
The operating modes F REEZE and SYNC are suppor ted by the
CP system in accordance with EN 50170 (DIN 19245).
The method of accessing the commands FREEZE and SYNC
depends on the controller used. Please refer here to the
documentation for your field bus module.
Caution
Inthefollowingcases,theFREEZEorSYNCmodewillbe
automatically reset:
– Switching on/off the CP system
– Stopping the field bus module
The FREEZE mode will also be reset automatically in the
following case:
– Bus connection to the CP system interrupted (response
monitoring active).
To Next Page
Loading...
