2. Commissioning
2-2
Festo Festo P .BE CP FB13-E-EN en 9910c
Contents
2.1 Preparing the CP system for operation on the PROFIBUS-DP 2-3............
2.1.1 Operating voltage 2-3...............................................
2.1.2 Saving the string assignment 2-3.....................................
2.1.3 Compiling the configuration list 2-4...................................
2.1.4 General information 2-5.............................................
2.2 Configuration with a Siemens master 2-13...............................
2.2.1 Preparations for COM PROFIBUS 3.x and 5.0 2-13.........................
2.2.2 Station selection with COM PROFIBUS 3.x 2-15...........................
2.2.3 Station selection with COM PROFIBUS 5.0 2-19...........................
2.2.4 Input and output address 2-23........................................
2.2.5 STEP 7 V4.x / 5.0 – Hardware configurator 2-25..........................
2.2.6 Commissioning the CP system on the PROFIBUS-DP 2-35...................
2.3 Operation with the general DP master 2-37..............................
2.3.1 Bus start 2-37......................................................
2.3.2 Send parametrizing data 2-38.........................................
2.3.3 Send configuration data 2-39.........................................
2.3.4 Request diagnostic information 2-41...................................
2.3.5 C yclic exchange of data 2-41..........................................
2.3.6 Summary of implemented functions and service access points (SAP) 2-43.....
2.3.7 Bus parameter/reaction times 2-44....................................
2.3.8 T ransmission times on the PROFIBUS-DP 2-44............................
2.4 Device data base (GSD) 2-45..........................................
To Next Page
Loading...
