Design and function
© Festo Didactic Conveyor 35
4 Design and Function
4.1 Transport
On delivery of the stations, special attention must be payed on transporting them only by a
suitable industrial truck.
The weight of a station may amount up to 50 kg.
Before the transport, all supply roads must be cleared to be passable for the industrial
truck. If necessary, you have to install warning signs or barrier tapes. When opening the
transport boxes you have to be very careful because additional components like computers
may also be delivered with the box and have to be protected against dropping out.
Do not grab the station at or even under the pedestals – high risk of being crushed or
jammed!
If the transport box is opened and the possibly additional components are taken out, you
can remove the station and bring it to its place of destination. Please check the stability of
all profile connectors with an Allen key size 4-6. It might happen that the connectors are
loosened during the transport due to inevitable vibrations. Please pay special attention to
any protruding components. Sensors or other small parts may easily be damaged during an
improper transport.
To Next Page
Loading...
