Festo CP Series User Manual

5. Maintenance and conversion
5.1 Fitting/removing CP terminal components . . . . . . . . . . . . . . . . . 5-3
5.1.1 Removing components from valve locations . . . . . . . . . . . . . . . 5-4
5.1.2 Fitting components into the valve locations . . . . . . . . . . . . . . . . 5-7
5.2 Conversion from pushing to locking manual override . . . . . . 5-12
5.3 Conversion from internal to external pilot air . . . . . . . . . . . . . 5-13
5.4 Conversion from individual to central tubing . . . . . . . . . . . . . . 5-18
5.5 Converting the CP valve terminal to two pressure zones . . . . 5-19
5.6 Converting the CP valve terminal to
different electrical connections . . . . . . . . . . . . . . . . . . . . . . . . . 5-20
A. Technical appendix
A.1 Accessories. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-3
A.2 Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-4
A.3 Index. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-9
IV CPV.. 9802

Festo CP Series Specifications

General

Type	Controller
Series	CP
Category	Controller
Manufacturer	Festo
Operating Voltage	24 V DC
Protection Class	IP20
Communication Interface	CANopen, PROFINET
Programming Environment	Festo Automation Suite
Number of Axes	Varies (depending on model, typically up to 6 or more)