Festo CP Series User Manual

Designated use
The CP valve terminals documented in this manual are
designated exclusively for controlling pneumatic actua-
tors and may only be used in conjunction with devices
and components from other manufacturers providing
these are recommended by Festo:
– as intended for use
– in original condition
– without unauthorized modifications
– in faultless technical condition.
The specified limit values for pressures, temperatures,
electrical data, torques etc. must be observed.
Please comply also with national and local safety laws
and regulations.
Target group
This manual is directed exclusively at technicians who
are trained in control and automation technology and
who have experience in the installation, commissioning
and maintenance of pneumatic components.
CPV... 9802 V

Festo CP Series Specifications

General

Type	Controller
Series	CP
Category	Controller
Manufacturer	Festo
Operating Voltage	24 V DC
Protection Class	IP20
Communication Interface	CANopen, PROFINET
Programming Environment	Festo Automation Suite
Number of Axes	Varies (depending on model, typically up to 6 or more)