Festo CP Series User Manual

2.2 CP terminal with pneumatic multiple connector plate
If you are using a pneumatic multiple connector plate,
the power supply and work lines will be connected at a
central point. This enables the supply and work lines to
be disconnected from the valve terminal easily and qui-
ckly.
PLEASE NOTE
Only CP terminals, which have been fitted with appro-
priate end plates, may be mounted on the pneumatic
multiple connector plate.
CP valve terminals, which have been fitted with end
plates for individual tubing, can be converted before
they are fitted onto the pneumatic multiple connector
plate.
In this case replace the end plates with multiple
connector end plates.
2. Fitting
2-10 CPV... 9802

Festo CP Series Specifications

General

Type	Controller
Series	CP
Category	Controller
Manufacturer	Festo
Operating Voltage	24 V DC
Protection Class	IP20
Communication Interface	CANopen, PROFINET
Programming Environment	Festo Automation Suite
Number of Axes	Varies (depending on model, typically up to 6 or more)