Festo CP Series User Manual

5.2 Conversion from pushing to locking manual override
By removing a safety clip, you can convert your CP
terminal from pushing to locking manual override. Pro-
ceed as follows:
If you do not wish to use the safety clip again:
• Use a screwdriver to press in the centre of the safety
clip, as shown in 1 . The safety clip will then bend
and can be removed from the fastening.
If you wish to use the safety clip again:
• Use a thin object (e.g. a spatula) to lift the safety clip
out of the fastening as shown in 2 .
1
2
Remove the safety clip by pressing it out
Remove the safety clip by lifting it out (clip can be used again)
Fig. 5/5: Safety clip of the manual override
1
2
5. Maintenance and conversion
5-12 CPV... 9802

Festo CP Series Specifications

General

Type	Controller
Series	CP
Category	Controller
Manufacturer	Festo
Operating Voltage	24 V DC
Protection Class	IP20
Communication Interface	CANopen, PROFINET
Programming Environment	Festo Automation Suite
Number of Axes	Varies (depending on model, typically up to 6 or more)