Festo CP Series User Manual

5.6 Converting the CP valve terminal to
different electrical connections
Due to the modular structure of the CP valve terminal,
you can convert it to IC, MP, AS-i or CP connections.
Proceed as follows:
CP terminals with IC connection
• Loosen the locking screws on the connecting
sockets.
• Pull the socket carefully away from the connecting
lugs on the pilot solenoid coil.
• Insert the MP, AS-i or CP connection onto the
connecting lugs of the pilot solenoid coils.
• Fasten the connector plate with the 4 socket head
screws. Tighten the screws in a diagonally opposite
sequence.
5. Maintenance and conversion
5-20 CPV... 9802

Festo CP Series Specifications

General

Type	Controller
Series	CP
Category	Controller
Manufacturer	Festo
Operating Voltage	24 V DC
Protection Class	IP20
Communication Interface	CANopen, PROFINET
Programming Environment	Festo Automation Suite
Number of Axes	Varies (depending on model, typically up to 6 or more)