Festo CP Series User Manual

5.4 Conversion from individual to central tubing
In order to convert your CP terminal from individual to
central tubing with the pneumatic multiple connector
plate, you will require the following:
– the pneumatic multiple connector plate
– special end plates for the CP terminal
Proceed as follows:
• Replace the end plates of the CP terminal as descri-
bed in the section "Conversion from internal to exter-
nal control air".
• Fit the pneumatic multiple connector plate as descri-
bed in chapter 2 in the section "Fitting the pneumatic
multiple connector plate".
5. Maintenance and conversion
5-18 CPV... 9802

Festo CP Series Specifications

General

Type	Controller
Series	CP
Category	Controller
Manufacturer	Festo
Operating Voltage	24 V DC
Protection Class	IP20
Communication Interface	CANopen, PROFINET
Programming Environment	Festo Automation Suite
Number of Axes	Varies (depending on model, typically up to 6 or more)