Festo CP Series User Manual

5.5 Converting the CP terminal to two pressure zones
In order to convert your CP terminal to two pressure
zones, you will require an isolating plate (to be ordered
separately).
Fit the isolating plate as described in the section "Fitting
components in the valve locations".
PLEASE NOTE
• When installing the CP terminal, you must supply
compressed air to both sides of the terminal.
• Seal unused connections (supply and auxiliary pilot
air connections) with blind plugs.
5. Maintenance and conversion
CPV... 9802 5-19

Festo CP Series Specifications

General

Type	Controller
Series	CP
Category	Controller
Manufacturer	Festo
Operating Voltage	24 V DC
Protection Class	IP20
Communication Interface	CANopen, PROFINET
Programming Environment	Festo Automation Suite
Number of Axes	Varies (depending on model, typically up to 6 or more)