EasyManua.ls Logo

Fiery E-41 - Page 76

Fiery E-41
161 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVICE PROCEDURES 76
7. If a monitor is connected to the E-41:
When the Log On to Windows dialog box appears on the monitor, type Administrator in
the user name field, type
Fiery.1 in the password field, and then press Enter on
the keyboard.
NOTE: Ty pe Fiery.1 exactly as shown. The password is case-sensitive; for example,
fiery.1 will not work.
Wait for Idle to display on FieryBar on the monitor.
If the E-41 is not connected to the copier/printer, or if the copier/printer is not powered
on, a message displays indicating the status. Expect this message. The E-41 detects the
copier/printer after you connect the E-41 to the copier/printer.
8. Reattach any dongle(s) (for example, for Compose or Impose) or USB storage device you may
have removed previously.
Error messages
One of the following error messages may display on the E-41 Control Panel or monitor when
you attempt to transfer options to the new motherboard.
Could not mount the dos/boot partitionYou have attempted to transfer options using the
Feature Update CD. The Feature Update CD is not supported by the E-41. Obtain the
Fiery Options Utility and try the procedure again.
Invalid dongle found! Please remove dongle and connect the correct dongleThe
attached dongle is not supported by the Fiery Options Utility. The dongle may have been
attached by mistake. Obtain a valid dongle and try again.
More than one dongle found. Remove all dongles except the correct dongleThe
Fiery Options Utility will not work when more than one dongle is attached to the system.
No uses remainingThe dongle has already been used and cannot be reused. Obtain an
unused dongle and start again.
Check power and Video cable connectionsThere is a problem with the connection
between the E-41 and the copier/printer. Make sure that the interface cables are properly
connected and the copier/printer is on and ready to print.
If an error condition cannot be corrected, restore the previous hardware configuration, if
possible, and contact your authorized service/support center.

Table of Contents