FLAMIC S.R.L. 5 Via dell’Artigianato, 36035 Marano Vicentino (Vicenza) - Italy
42
Dough sheeter SF450 - SF500 - SF600 Operation and maintenance manual (translation of original instructions) – Ed. 10/2016
Rev.02 10/2017
All rights reserved. Reproduction in whole or in part of this manual is prohibited.
4.5.2.3 MOD. SF600
With reference to Figure 36, to remove a scraper ref. 1 lower the lever completely ref. 2. The scraper will move
away from the conveyor belt and the thicknessing roller (photo B) and can then be removed by pulling it
upwards.
To install a scraper ref. 1:
- lower the scraper unit ref. 4 into the space ref. 5 between the belt ref. 6 and the thicknessing roller ref. 7. The
bevelled part ref. 8 of the plate ref. 9 must be facing towards the roller ref. 7 (photo D).
- allow the scraper ref. 1 to rest against its lower limit stop (photo F), then lift the lever ref. 2 completely (photo
E).
Figure 36 - Mod. SF600: removing/installing the lower roller scrapers
1
2
4
5 7 6
8 9
A
B
C
D
E
To Next Page
Loading...
