A Menu structure FLUXUS F808, F809
UMFLUXUS_F808_8091V1-2-1EN, 2019-08-23 177
confirmation that the changes are to be stored
This display will only be indicated if a new fluid has been entered or the proper-
ties of an existing fluid have been changed.
Program Code
selection of the displays for the input of a program code
defining a program code
input of the break code (= program code)
input of the access code (= the first three digits of the program code)
After the input of HotCode 071001
input of the lower limit of the inner pipe diameter for the displayed transducer
type
range: 3...63 mm
x
INIT-
resistant
Save changes
no >YES<
Special Funct. ↕
set program code
set program code
------
INPUT BREAK_CODE
CODE: 000000
INP. ACCESS CODE
CODE: 000000
DNmin Q-Sensor
15 mm