Flexim FLUXUS WD - Deletion of the Data Logger; Information Relating the Data Logger; Print of Measured Values

15 Data logger
FLUXUS WD 15.2 Deletion of the data logger
121
UMFLUXUS_WDV1-3EN, 2018-07-16
Acoustic signal during the storing
The storing of each measured value can be acoustically signalized. The signal can be activated or deactivated in the pro-
gram branch Special functions\
Data logger \ Configuration\Beep on storage.
•Select On to activate the acoustic signal. Select Off to deactivate the acoustic signal.
• Press ENTER.
15.2 Deletion of the data logger
• Select the menu item Delete meas. values in the program branch Special functions\Data logger.
• Press ENTER.
•Select Yes or No.
• Press ENTER.
15.3 Information relating the data logger
• Select the menu item Data logger info in the program branch Special functions\Data logger.
• Press ENTER.
The following information relating the data logger is displayed:
15.4 Print of measured values
• Start the terminal program.
• Enter the transmission parameters into the terminal program. The transmission parameters of the terminal program and
the transmitter have to be identical, see section 15.5.
•Select Special functions\Data logger\Print meas. values.
This display will only be indicated if the transmitter has an RS485 interface.
• Press ENTER.
Special functions\ Data logger\ Configuration\Beep on storage
Special functions\ Data logger\Delete meas. values
Special functions\ Data logger\ Data logger info
display description
Activated: activated/deactivated data logger
This display will only be indicated if the measurement has started and the data logger is activated.
Logger full: data logger is full/not full
Ringbuffer: ringbuffer is activated/deactivated
Meas. val. series: number of stored series of measured values
Occup. logger.: percentage of memory actually used
Special functions\Data logger\Print meas. values