Flexim FLUXUS WD - Settings; Dialogs and Menus

18 Settings
18.1 Dialogs and menus FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
142
18 Settings
18.1 Dialogs and menus
• Select the menu item Dialogs/Menus in the program branch Special functions.
• Press ENTER.
Pipe circumference
• Select the menu item Pipe circumference.
•Select Yes if the pipe circumference is to be entered instead of the pipe diameter in the program branch Parameters.
• Press ENTER.
If Yes is selected for Pipe circumference, the outer pipe diameter will be requested in the program branch Parameters.
• Press key to select the menu item Pipe circumference.
• Press ENTER.
The value displayed in the menu item Pipe circumference is calculated from the last displayed outer pipe diameter.
Example: 100 mm
.
 = 314.2 mm
• Enter the pipe circumference. The limits for the pipe circumference are calculated on the basis of the limits for the outer
pipe diameter.
• Press ENTER.
During the next scroll through the program branch Parameters, the outer pipe diameter that corresponds to the entered
pipe circumference will be displayed.
Example: 180 mm :  = 57.3 mm
Coating
If the pipe has a coating, the material parameters of the coating have to be entered in the program branch Parameters.
• Select the menu item Edit coating.
•Select Yes if the pipe has a coating.
• Press ENTER.
Lining 2
If the pipe has a second lining, the material parameters of the coating have to be entered in the program branch Parameters.
• Select the menu item Edit Lining 2.
•Select Yes if the pipe has 2 linings.
• Press ENTER.
Special functions\Dialogs/Menus
Special functions\Dialogs/Menus\Pipe circumference
Special functions\Dialogs/Menus\Edit coating
Special functions\Dialogs/Menus\Edit Lining 2