Flexim FLUXUS WD - Outputs

7 Connection
FLUXUS WD 7.3 Outputs
63
UMFLUXUS_WDV1-3EN, 2018-07-16
7.3 Outputs
• Connect the output cable to the transmitter.
For the connection of the output cable to the transmitter, see section 7.2.1, Fig. 7.12 and Tab. 7.7.
Fig. 7.11: Cable gland for aluminum housing
1 – cap nut
2 – compression part
3 – basic part
Important!
The max. permissible voltage between the outputs and against PE is 60 V DC (permanent).
Fig. 7.12: Connection of the outputs on the transmitter
Tab. 7.7: Circuit of the outputs
output transmitter external circuit remark
internal circuit connection
active current output/HART current output
R
ext
< 500 
HART
U
int
= 24 V
The number, type and the connections of the outputs depend on the order.
R
ext
is the sum of all ohmic resistances in the circuit (e.g., resistance of the conductors, resistance of the amperemeter/voltmeter).
21 3
A
B
SNAP
DISP
DISP
MODEFAST
MUX
NEXT
Q
ON
Q+Q-
3x Q
OFF
LAN
USB
A+ B- P1+ P2+ P3+ P4+
P5a
P6a P7a
S S P1- P2- P3- P4-
P5b
P6b P7b
X2 X3
X_AV
KL11 KL12 KL7KL8 KL9KL10
KL4
X_AR X_BV X_BR
T1A T1B S1 T2A T2B T3A T3B S3 T4B T4A
T1a T1b S1 T2a T2b T3a T3b S3 T4b T4a
N(-)
PE
L(+)
AV AVS AGN ARS AR BV BVS BGN BRS BR
A+ B- P1+ P2+ P3+ P4+
P5a
P6a P7a
S S P1- P2- P3- P4- P5b P6b P7b
KL9KL10
+
-
Px+
Px-
+
-
mA
ƒ
G
+
-
U
int
Px+
Px-
ƒ
G
mA