Flexim FLUXUS WD - Units of Measurement

18 Settings
FLUXUS WD 18.4 Units of measurement
145
UMFLUXUS_WDV1-3EN, 2018-07-16
Multi-point calibration
A multi-point calibration allows a very precise output of measuring results. The basis for the multi-point calibration offer
calibration curves of measurement series.
• Select the menu item Multi-point calibration.
•Select On to activate the multi-point calibration. Select Off to deactivate it.
• Press ENTER.
•Select Default (Multi-point calibration = Off) if no user-defined inputs are to be made.
• Press ENTER.
If On is selected, a series of measured values have to be entered in the program branch Options.
Swift damping
If Swift damping is activated, each displayed measured value is a floating average of the last x seconds, with x being
the damping factor. The display thus takes x seconds to fully respond to flow rate changes.
If Swift damping is deactivated, the damping is calculated as first order low-pass filter, i.e. changes of measured values
become effective in form of an exponential time course in the measuring result.
• Select the menu item Swift damping.
•Select On to activate Swift damping. Select Off to deactivate Swift damping.
•Select Default (Swift damping = On) if no user-defined inputs are to be made.
• Press ENTER.
18.4 Units of measurement
It is possible to set the global units of measurement for length, temperature, pressure, sound speed, density and kinematic
viscosity.
• Select the menu item Units of measurement.
• Press ENTER.
• Select a unit of measurement for all quantities.
• Press ENTER.
In this menu item it is possible to define which barrel type is to be displayed as unit of measurement for the volumetric flow
rate.
• Select a barrel type.
• Press ENTER.
Special functions\Measurement\Measurement settings\Multi-point calibration
Special functions\Measurement\Measurement settings\Swift damping
Special functions\Units of measurement
Special functions\Units of measurement\Barrel type