Flexim FLUXUS WD - Measuring Modes; Measurement Settings

18 Settings
18.2 Measuring modes FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
144
Toggle time
The toggle time indicates the time interval after which the transmitter (operating in AutoMux mode) toggles between the
different channels during the measurement. The default value is 3 s.
• Select the menu item Toggle time.
• Enter a different toggle time value if the default value is no to be used.
• Press ENTER.
This value remains stored until a new toggle time is entered.
Switching off the display backlight
•Select Yes to activate the automatic switch-off.
• Press ENTER.
If the automatic switch-off of the display backlight is activated, the backlight is switched off after about 30 s. When press-
ing a key or connecting a USB cable, the backlight is switched on again.
18.2 Measuring modes
• Select the menu item Measurement in the program branch Special functions.
• Press ENTER.
• Select the menu item Measurement modes.
• Press ENTER.
FastFood mode
•Select On to enable the measurement in the FastFood mode or Off to disable it.
• Press ENTER.
18.3 Measurement settings
• Select the menu item Measurement in the program branch Special functions.
• Press ENTER.
• Select the menu item Measurement settings.
• Press ENTER.
Special functions\Dialogs/Menus\Toggle time
Special functions\Dialogs/Menus\Light autom. off
Special functions\Measurement\Measurement modes
Special functions\Measurement\Measurement modes\Enable FastFood
Special functions\Measurement\Measurement settings