Flexim FLUXUS WD - Diagnosis by Means of the Snap Function

17 Advanced functions
FLUXUS WD 17.4 Diagnosis by means of the snap function
133
UMFLUXUS_WDV1-3EN, 2018-07-16
• Select the source item Extended diagnost.
• Press ENTER.
• Select the list item for which a condition is to be defined, see Tab. 17.3.
• Press ENTER.
17.4 Diagnosis by means of the snap function
17.4.1 Configuration
By means of the snap function it is possible to store measuring parameters which are useful for the evaluation of measur-
ing results or diagnosis purposes. To make use of the snap function it has to be configured.
• Select the menu item Configuration in the program branch Special functions\Snap.
• Press ENTER.
•Select On to activate the snap function.
• Press ENTER.
•Select Yes to activate the snap ringbuffer.
If the snap ringbuffer is activated, after taking the 51th, snap the oldest snaps are overwritten. If the ringbuffer is deactivat-
ed, up to 50 snaps can be stored.
• Press ENTER.
•Select Yes to activate Auto snap.
If Auto snap is activated, snaps are automatically stored during a measurement failure.
• Press ENTER.
•Select Yes if an event has been parameterized on the event trigger R1 which, at time of occurrence, has to release a
snap.
• Press ENTER.
Options\Channel Y\Event trigger\Enable Rx\Source item
Special functions\Snap\Configuration
Special functions\Snap\Configuration\Snap
Special functions\Snap\Configuration\Snap ringbuffer
Special functions\Snap\Configuration\Auto snap
Special functions\Snap\Configuration\Snap on R1