18 Settings
FLUXUS WD 18.9 Key lock
149
UMFLUXUS_WDV1-3EN, 2018-07-16
Intervention in the measurement
If the key lock is activated, the message Key lock activated will be displayed for a few seconds when pressing a key.
In order to interrupt a measurement, the key lock has to be deactivated.
• Press key .
•Select Show parameters.
• Press ENTER.
• Deactivate the key lock.
Deactivation of the key lock
• Select the menu item System settings in the program branch Special functions.
• Press ENTER.
•Select Key lock.
• Press ENTER.
• Enter a 6-digit key lock code.
• Press ENTER.
Disabled functions with activated key lock
The following table gives an overview of the transmitter functions that are not available when the key lock is activated.
Special functions\System settings\Key lock
measurement not started measurement started
• input of parameters
• modification of settings (e.g., measuring modes)
• deletion of the data logger
• setting of time/date
• start of measurement (start-up)
• modification of settings that are available in an ongoing
measurement (e.g., language selection)
• triggering snaps
• toggling to FastFood mode
• toggling to NoiseTrek mode
• stop of the totalizers
• reset of the totalizers
• stop of the measurement
To Next Page