4 Product description
4.2 Handling concept FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
20
For a description of the individual program branches, see Tab. 4.1.
After connecting the transmitter to the power supply and starting up the transmitter for the first time, the following settings
according to language, time, date and units of measurement have to be made, see section 8.1. The program branch
Parameters will be displayed. Any further start-up will display the measured value in case the measurement was not
stopped before the transmitter has been disconnected from the program branch. If the measurement is stopped, the pro-
gram branch Parameters will be displayed.
After starting the measurement, the parameter settings or configuration of the transmitter outputs can be displayed without
interrupting the measurement. A change is not possible. For this, the measurement has to be stopped.
Tab. 4.1: Description of the program branches
program branch description
Parameters Before starting a measurement, the transducer, pipe and fluid parameters have to be entered in the
program branch Parameters.
Measurement After activating the measuring channels and the input of the transducer distance, the measurement is
started in the program branch Measurement.
Options Channel-related settings are carried out in the program branch Options as e.g., selection of the
physical quantity, selection of the unit of measurement, input of the damping factor, assignation of the
inputs.
Special functions Global settings, relating the transmitter and all measuring channels, are carried out in the program
branch Special functions, as e.g. system settings (language, key lock), measuring settings,
communication, data logger, snaps, configuration of inputs.
To Next Page
Loading...
