6 Installation
6.2 Transducers FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
34
6.2.2 Installation of the transducers
6.2.2.1 Orientation of the transducers and determination of the transducer distance
Observe the orientation of the transducers. If the transducers have been mounted properly, the engravings on the trans-
ducers form an arrow, see Fig. 6.10. The transducer cables show in opposite directions.
The transducer distance is measured between the inner edges of the transducers.
• Select the installation instructions that correspond to the supplied transducer mounting fixture.
Fig. 6.10: Orientation of the transducers and transducer distance
a – transducer distance
To Next Page
Loading...
