Operation
Operators manual 33
FDS 400-301
Select the file(s) by pressing the right button.
Press the left button to return to the Storage Operations menu.
Select Copy Files then Select Memory Device and press the right button to confirm.
To delete, select Delete Files.
4.6.2 Other storage operations
To determine the storage used on any memory device, from the Storage Operations
menu, press the right button on the Storage Usage command, and then press the can-
cel button to exit.
To format a memory device, from the Storage Operations menu, press right on the For-
mat command, and then select the memory device you want to format.
4.6.3 File transfer PC to HHMPI
When connected to a PC the internal memory of the HHMPI will appear as a write-pro-
tected external hard drive, therefore files may only be copied from the HHMPI to the PC.
To erase files from the HHMPI internal memory, see Section 4.6.1, ”File transfer between
HHMPI storage locations” on page 32.
4.7 Network
operations
The HHMPI is capable of transferring files over a network using FTP and also for device
configuration in any web browser.
4.7.1 DHCP network settings
To view DHCP (automatic) network settings:
Navigate to Wired Settings as above.
Select Enable Networking, checking or un-checking the check box enables or disa-
bles the Manual Configure IP address option.
Choose between Auto and Manual DHCP.
Auto Configure DHCP by setting the checking the check box.
OR
Manually configure the IP address by pressing right on the Manual Configure com-
mand.
Use the up button to set the IP Address, Netmask and Gateway.
Press the OK button.
See Figure 24.0, ”DHCP or manual IP configuration”, on page 34.
▼▲
Main Menu > Storage Operations > Storage Usage
▼▲
Main Menu > Storage Operations > Format > Select Memory Device
▼▲
Main Menu > Device Configuration > Network Settings > Wired Set-
tings
To Next Page
Loading...