Flintec FT-111 D - Installation

FT-111(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 16 of 146
3.6 Passwords
RELATED PARAMETERS: Sub-block 26- .
Key lock
FT-111 has capability to lock the keys to avoid unauthorized interfere. The key(s) which would be locked are programmed in
the setup at sub-block 34- . Key lock password default is 11.
Lock the keys:
1. Press key for more than 2 seconds. [PASSWORD: ] prompt appears on the display.
2. Press key.
3. Press key. symbol appears on the display.
Unlock the keys:
1. Press key for more than 2 seconds. [PASSWORD: ] prompt appears on the display.
2. Press key.
3. Press key. symbol disappears on the display.
Passwords
User password
This password is used to setup the interface, usage configuration and application related parameters for
your application.
To enter the programing;
Display
Operation
[123.456 kg]
Press key until [ PASSWORD : ] prompts seen.
[PASSWORD]
+ + keys sequentially for user entry.
[*** ]
Press key.
[1—INTERFACE ]
You entered to the programming main menu and the first main block
[1—INTERFACE ] prompt appears.
Service password
This password is used to interfere the instrument parameters and calibration only by trained technical
persons. Refer to section 6.1 on page 41.