Flintec FT-111 D - Page 58

FT-111(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 57 of 146
[ 3-- APPLICATION ] Application Block
[
3--
APPLICATION
]
APPLICATION RELATED PARAMETERS MAIN BLOCK
Press key sequentially to access this main block,
or press key or key to enter configuration parameters,
or press key to go to the next block,
or press key to exit from programming.
[
33-
DYNAMIC
]
WEIGHING OF UNSTABLE LOADS
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
331
OPERATE
:
NO
]
Operation type
Page 37
NO
KEY
SAUT
:
:
:
Disable
Dynamic weighing starts after repressing the
key if W >50e.
Dynamic weighing starts automatically if W >50e.
CONT
MINW
CMIN
:
:
:
Continuous dynamic weighing.
Dynamic weighing starts if W > Min Weight.
Continuous dynamic weighing starts if W > Min
Weight.
[
332
FILTER
:
3.0
]
Dynamic filtering time.
X.X seconds.
[
34-
KEY LOCK
]
KEY LOCK
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
341
UP KEY
:
USE
]
Setpoint key locking
USE
LOCK
:
:
Not locked
Locked
[
342
DOWN
:
USE
]
Memory key locking
USE
LOCK
:
:
Not locked
Locked
[
343
RIGHT
:
USE
]
Right arrow key locking
USE
LOCK
:
:
Not locked
Locked
[
344
LEFT
:
USE
]
Left arrow key locking
USE
LOCK
:
:
Not locked
Locked
[
345
ENTER
:
USE
]
Enter key locking
USE
LOCK
:
:
Not locked
Locked
[
346
* KEY
:
USE
]
* key locking
USE
LOCK
:
:
Not locked
Locked