Flintec FT-111 D - Page 60

FT-111(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 59 of 146
[
36-
DIG OUTPUTS
]
DIGITAL OUTPUTS (appears if option installed)
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
361
OUT 1
:
NO
]
Digital output 1
Page 75,
NO
S AIN
S IND
S ANE
:
:
:
:
Disable
Absolute Indicated weight
Indicated weight
Absolute net weight
S NET
S GRO
SPC1
SPC2
STAB
NET
ZR I
ZR G
RUN
ERRO
FBUS
:
:
:
:
:
:
:
:
:
:
:
Net weight
Gross weight
Control mode-1
Control mode-2
Weighing is stable
Net weighing
Zero range of indicated weight
Zero range of gross weight
In usage
Error
Remote Output over Fieldbus or
BSI
Press key to select output function if you need function
different than basic setpoint output and active high level. Available
functions are seen on the weight display. Press key after set up
the output function. Refer to Section 8.2 for details.
( only at SAIN, SIND, SANE, SNET, SGRO )
[
BAS-HI
]
BAS-HI
BAS-LO
THR-HI
THR-
LO
VIN-HI
VIN-LO
:
:
:
:
:
:
Basic setpoint output, active high
Basic setpoint output, active low
Threshold, active high
Threshold, active low
Window, active high
Window, active low
[
362
OUT 2
:
NO
]
Digital output 2
Page 75,
:
[
363
OUT 3
:
NO
]
Digital output 3
Page 75,
:
[
364
OUT 4
:
NO
]
Digital output 4
Page 75,
:
[
365
OUT 5
:
NO
]
Digital output 5
Page 75,
:
[
366
ZR [d]
:
1.0
]
Zero range in XX.X division. Default is 1.0 d.
Page 83
For example: if the scale division is 0.5 kg and this parameter
entry is 1.0 division.
The output is activated if the indication is lower than 0.5 kg.
[
367
OUTPUTS
:
IMME
]
Output changing.
IMME
STAB
:
:
Immediately change even scale is not stable.
Change if the scale is stable.