Flintec FT-111 D - Calibration

FT-111(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 66 of 146
[
97-
FIRMWARE
]
FIRMWARE INFORMATION
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
971
INSTRUMENT
]
XX.XX
[
972
OPTION
]
XX.XX
[
973
UPGRADE
]
M
Firmware upgrade
Call Flintec service or dealer to upgrade.
[
974
DLC BOARD
]
XX.XX (only FT-111 D)
[
99-
DEFAULT
]
DEFAULTS LOADING
Press key or key again to enter this menu.
Press key to go to beginning of the sub-block or press
key
to go to the next main block.
[
993
PARAMET DEF
]
M
Load parameter's default
(Calibration do not change )
[
994
FACTORY DEF
]
M
Load factory defaults
[
995
DEFAULT ADDR
]
M
Load default address to digital load cell. (only FT-111 D)
The default address feature solves the problem and provides
access to the load cell functions even if its address and its serial
number are not known.
WARNING: The DLC must be disconnected from the network and
connect as single.