Fluke 5730A User Manual

Front-Panel Operation
Instrument Settings 4
4-57
Language
To select the display language used for the 5730A Calibrator UI:
1. Touch Setup Menu>Instrument Settings>Language.
2. Touch the necessary language from the screen. The choices are:
• English
• French
• Spanish
• Simplified Chinese
• Japanese
• German
• Portuguese
• Russian
• Korean
Note
The new language does not take effect until the Calibrator is powered down
and back up again. Push  on the front panel.
Display Brightness
To adjust the brightness of the display:
1. Touch Setup Menu>Instrument Settings>Display.
2. Touch the field in the Brightness selection and enter the necessary value with the
numeric keypad. Note that with brightness setting of 0 %, the display is still visible.
About This Instrument
About this Instrument in the setup menu gives access to this information:
• Installed internal operating software revision letters.
• Whether the Wideband AC Module (Option 5730A/03 or 5730A/05) is installed.
• Which auxiliary amplifiers are attached, if any.
To view this information, touch Setup Menu>About This Instrument.
Much of the information is summarized in this menu. Touch Software Information to
get more detail about the installed firmware. Touch Hardware Information to get more
detail about installed assemblies and attached auxiliary amplifiers.

Fluke 5730A Specifications

General

Type	Multifunction Calibrator
Resistance Range	0 to 1 GΩ
AC Voltage Frequency	10 Hz to 1 MHz
Display	Color LCD
Interfaces	RS-232, Ethernet
Weight	18 kg
DC Voltage Range	0 to ±1100 V
Dimensions	172 mm H x 432 mm W x 457 mm D (6.8 in H x 17 in W x 18 in D)