Fluke 5730A User Manual

A-1
Appendix A
Fault Codes
0-Level Faults: Firmware Updater
1 Backup directory not specified in AuxInfo
2 Backup filename not specified in AuxInfo
3 Destination directory not specified in AuxInfo
4 Destination filename not specified in AuxInfo
5 Error extracting required file transfer data from AuxInfo
6 Error retrieving parameter value from AuxInfo
7 Error retrieving section name from AuxInfo
8 Interim directory not specified in AuxInfo
9 Interim filename not specified in AuxInfo
10 Error reading AuxInfo file
11 Source directory on USB device not specified in AuxInfo
12 Source filename on USB device not specified in AuxInfo
13 Cannot build a list of sequences to be executed
14 Backup directory not specified in AuxInfo (config/cal)
15 Backup file not specified in AuxInfo (config/cal)
16 Destination directory not specified in AuxInfo (config/cal)
17 Destination file not specified in AuxInfo (config/cal)
18 Source directory not specified in AuxInfo (config/cal)
19 Source file not specified in AuxInfo(config/cal)
20 Error setting mode of new file
21 Timestamp too long in AuxInfo
22 Cannot close updated file (config/cal)
23 Destination file does not exist (config/cal)

Fluke 5730A Specifications

General

Type	Multifunction Calibrator
Resistance Range	0 to 1 GΩ
AC Voltage Frequency	10 Hz to 1 MHz
Display	Color LCD
Interfaces	RS-232, Ethernet
Weight	18 kg
DC Voltage Range	0 to ±1100 V
Dimensions	172 mm H x 432 mm W x 457 mm D (6.8 in H x 17 in W x 18 in D)