Fluke 5730A User Manual

4-1
Chapter 4
Front-Panel Operation
Introduction
This chapter provides instructions to operate the 5730A Calibrator from the front panel
and how to set up the Calibrator. Remote interface setups are explained in Chapter 5.
Descriptions and instructions to program offsets, scale factors, and linearity checks are
also provided.
Before the procedures in this chapter are started, become familiar with the front-panel
controls, displays, and terminals that are identified and described in Chapter 3. Once
familiar with the front panel, be sure to warm up the Calibrator in accordance with the
instructions in the “Warmup” section. Also run the dc zeros process as explained in the
“Run DC Zeros” section of Chapter 7. For information on remote commands used to
operate the Calibrator, refer to Chapter 6.
Warning
The Product is capable of supplying lethal voltages. Do not
make connections to the output terminals when any voltage is
present. Placing the Product in standby may not be enough to
prevent shock hazard, since the  key could be pushed
accidentally. Push  and verify that standby is illuminated
before making connections to the output terminals.

Fluke 5730A Specifications

General

Type	Multifunction Calibrator
Resistance Range	0 to 1 GΩ
AC Voltage Frequency	10 Hz to 1 MHz
Display	Color LCD
Interfaces	RS-232, Ethernet
Weight	18 kg
DC Voltage Range	0 to ±1100 V
Dimensions	172 mm H x 432 mm W x 457 mm D (6.8 in H x 17 in W x 18 in D)