Fluke 5730A User Manual

5730A
Operators Manual
5-8
Set a Static Internet Address
The 5730A Calibrator comes from the factory with 169.254.001.001 in the static IP
address register.
Note
If the Calibrator is to be used on a corporate LAN and DHCP is not used,
contact the network administrator for a static IP address to be used
exclusively by the Calibrator. DHCP must be disabled to set a static IP
address.
To change the Calibrator static IP Address:
1. Touch Setup Menu>Instrument Setup>Remote Port>Ethernet Setup to get to the
Ethernet Setup menu.
2. Touch IP Address.
3. Use the numeric keypad to enter the IP address and then push .
If a mistake is made when the IP address is entered,  must be pushed.
Note
The IP address is stored in non-volatile memory, and does not change when
power is removed and reapplied to the Calibrator or when the Calibrator
receives an *RST command.
Configure the General Network Socket Port
In order to communicate with each other, a client computer and the 5730A Calibrator
must use the same socket port number. The default port is 3490. Typically, the default
port does not need to be changed. If the socket port must be changed, enter the Socket
Port number supplied by the network administrator.
To change the Socket Port number:
1. Touch Setup Menu>Instrument Setup>Remote Port>Ethernet Setup to get to the
Ethernet Setup menu.
2. Touch PORT.
3. Use the numeric keypad to enter a new port number.
4. Push . The port number must be between 1024 to 65535.
If a mistake is made when the socket port is entered, push  and go back to step 2
to enter the port number again.
Note
The Network Socket Port Number is stored in non-volatile memory.

Fluke 5730A Specifications

General

Type	Multifunction Calibrator
Resistance Range	0 to 1 GΩ
AC Voltage Frequency	10 Hz to 1 MHz
Display	Color LCD
Interfaces	RS-232, Ethernet
Weight	18 kg
DC Voltage Range	0 to ±1100 V
Dimensions	172 mm H x 432 mm W x 457 mm D (6.8 in H x 17 in W x 18 in D)