Fluke 5730A User Manual

2-1
Chapter 2
Installation
Introduction
Warning
The Product can supply lethal voltages to the binding posts.
Read this chapter before you use the Product.
This chapter has instructions to unpack and install the 5730A Calibrator. The procedures
for line voltage selection and connection to mains power are provided here.
Instructions for cable connections, other than line power connection, can be found in
these chapters of the manual:
• UUT (Unit Under Test) connections: Chapter 4
• Remote interface connection (IEEE-488/RS-232/USB/LAN): Chapter 5
• Option 5730/03 and 5730/05 Wideband AC Module connection: Chapter 4
• Auxiliary amplifier connections: Chapter 4
Unpack and Inspect the Calibrator
The 5730A Calibrator ships in a container that prevents shipping damage. Inspect the
Calibrator carefully for damage, and immediately report any damage to the shipper.
Instructions for inspection and claims are included in the shipping container.
When the Calibrator is unpacked, check for all the standard equipment listed in Table 2-1
and check the shipping order for additional items ordered. See Chapter 8 for information
about options and accessories. Report any shortage to the place of purchase or to the
nearest Fluke Calibration Service Center. See “How to Contact Fluke Calibration” if
necessary. If performance tests are necessary for your acceptance procedure, they can be
found in Chapter 7.

Fluke 5730A Specifications

General

Type	Multifunction Calibrator
Resistance Range	0 to 1 GΩ
AC Voltage Frequency	10 Hz to 1 MHz
Display	Color LCD
Interfaces	RS-232, Ethernet
Weight	18 kg
DC Voltage Range	0 to ±1100 V
Dimensions	172 mm H x 432 mm W x 457 mm D (6.8 in H x 17 in W x 18 in D)