Fluke 5730A - Page 228

5730A
Operators Manual
A-18
3207 5725 ACV VLF (100 Hz) will not Converge
3208 5725 ACV LF (1 kHz) will not Converge
3209 5725 ACV MF (10 kHz) will not Converge
3210 5725 ACV HF (100 kHz) will not Converge
3211 5725 Current Path To Shunt Open
3212 5725 Shunt Sense Open
3213 5725 Shunt Measurement Out Of Tolerance
3214 5725 Current Amplifier Offset Too Large
3215 5725 Current Drive Path Open
3216 5725 Current Error Amplifier Failure
3217 5725 Amplifer Not Connected
3300-Level Faults: Self Diagnostics (Ohms)
3300 A9: 8255 Control Word
3301 A9: 8255 Port A Fault
3302 A9: 8255 Port B Fault
3303 A9: 8255 Port C Fault
3304 A9: 10 V Source Fault
3305 A9: 5 V Source Fault
3306 A9: 2 V Source Fault
3308 A9: Diff Amp Offset Fault
3309 A9: Diff Amp Gain Fault
3310 A9: Diff Amp Noise Fault
3311 A9/A10: Ohms 10:1 Divider Fault
3312 A9/A10: Ohms 1:1 Divider Fault
3313 A9/A10: 10 KΩ Diagnostic Fault
3314 A9/A10: 19 KΩ Cal Diag Fault
3315 A9/A10: 10 Ω Cal Diag Fault
3316 A9/A10: 19 Ω Cal Diag Fault
3317 A9/A10: 100 KΩ Ratio Fault
3318 A9/A10: 190 KΩ Ratio Fault
3319 A9/A10: 1 MΩ Ratio Fault
3320 A9/A10: 1.9 MΩ Ratio Fault
3321 A9/A10: 10 MΩ Ratio Fault
3322 A9/A10: 19 MΩ Ratio Fault 1