Front-Panel Operation
Set the Output 4
4-15
For the selections with indicators, the value shown is the value now in effect. For
example, if the External Guard selections says OFF, then external guard is off and
touching the selection will turn it on.
To set the output, push this key sequence to select an output function and amplitude:
[numeric keys] , [multiplier], [function] , ,
For example, to set the output to 10 mV dc, push:
To set an ac output, push these additional keys:
[numeric keys] , [multiplier] , ,
For example, to change the present 10 mV dc to 10 mV ac at 1.8 kHz, push:
To change the output back to dc, push:
or
The subsequent step-by-step procedures explain how to set an output and how to use the
features available for each output function:
• DC voltage
• AC voltage
• DC current
• AC current
• Resistance
• Wideband ac voltage (5730A/03 or 5730A/05 Option)
• Variable phase
• Boost operation (with an auxiliary amplifier)
To Next Page
Loading...
