Fluke 5730A - Page 83

Front-Panel Operation
Set the Output 4
4-27
9. The display now shows the amplitude of the entry. If an entry error is made, push 
to clear the display, then reenter the value. If the most recent digit entered is in error,
push  to clear that digit. The illustration of the display below assumes an entry of
20 dBm:
dBm
kHz
1.0000
42.00000
+/- 1.37 % (1 year) 213 days since calibration
4/14/2013 13:40
Setup
Menu
Standby
μV
kHz
1.0000
Auto Range 1.1 mV
350.00
Wideband
ON
20dBm
hhp125.eps
10. With the numeric keypad, enter a frequency, followed by  or  if necessary.
The display now shows the amplitude and frequency of the entry. If an entry error is
made, push  to clear the display, then reenter the value. If the most recent digit
entered is in error, push  to clear that digit. The display shown below assumes an
entry of 21 MHz:
dBm
kHz
1.0000
42.00000
+/- 1.37 % (1 year) 213 days since calibration
4/18/2013 13:40
Setup
Menu
Standby
μV
kHz
1.0000
Auto Range 1.1 mV
350.00
Wideband
ON
20dBm 21MHz
hhp126.eps