Fluke 9190A - Chapter 2; Introduction; Calibrator Features

Operation
Introduction 2
2-3
Introduction
This chapter supplies instructions on how to set up and operate the Calibrator. The
control panels and features of the Calibrator are described first, followed by setup, menus,
and operation.
Calibrator Features
Table 2-1 identifies and describes the panels on the front of the Calibrator.
Table 2-1. The 9190A Front Panel
9190A Model
9190A
1
3
gzs046.eps
9190A-P Model
9190A
1
2
3
gzs001.eps
Item Name Function
 Display and Control Panel
Control panel and display. See “Display and Control Panel” on
page 2-4.
 -P Option Panel (Input Panel)
Input panel used to connect to external sensors and probes.
Panel is only available on the “-P” model. See “-P Option Panel”
on page 2-5.

Power and Remote Interface
Panel
Power module and Remote Interface Panel. See “Power and
Remote Interface Panel” on page 2-6.