Remote Operation
Remote Operation Setup 3
3-5
Communication Setup
To use the RS-232 Remote Serial Interface, the Calibrator must be configured to
communicate with the computer. Configuration is done in the Communication Setup
menu on the Calibrator.
Table 3-2. Communication Setup Menu
66.03°C
COMMUNICATION SETUP
BAUD RATE: 9600
LINEFEED: ON
COMM
SETUP
SYSTEM
MENU
SYSTEM
SETUP
MENU
1
2
gzs016.eps
Item Function
BAUD RATE is the serial communication transmission rate or baud rate. BAUD may be set to
1200, 2400, 4800, 9600, 19200, or 38400 baud.
LINEFEED turns on or turns off transmission of a line feed character (LF, ASCII 10) after
transmission of any carriage-return.
Set up communications as follows:
1. Push .
2. Push .
3. Push .
4. Push .
5. Highlight
BAUD RATE and push .
6. Push or to change the
BAUD RATE (see item in Table 3-2).
Note
Set the BAUD RATE to the baud rate that the computer serial port is
configured for.
7. Push to save.
To Next Page
Loading...
