Fluke 9190A - RTD Setup

9190A
Operators Manual
2-24
RTD Setup
Table 2-25 shows and describes the menu selections on the RTD Setup menu.
Note
The selections in the SETUP INPUT menu is dependent on the Sensor Type
selected in the SELECT INPUT menu. The SETUP INPUT menu is used to
set up the UUT input or to run the test algorithm.
Table 2-25. RTD Setup Menu
66.03°C
RTD SETUP
WIRES: 3
INPUT
SETUP
SETUP
INPUT
RTD
SETUP
RTD TYPE: RESISTANCE
MENU
1
2
gzs027.eps
Item Function
 WIRES configures the RTD input for a 2, 3, or 4-wire input.

RTD TYPE sets up the conversion type for the RTD. RTD characterization types include
PT100(385), PT100(392), PT100(ITS), NI-120, and RESISTANCE.
Note
When RESISTANCE is selected the RTD resistance is shown instead of
temperature.