Calibration
Introduction 4
4-3
Introduction
This chapter contains calibration procedures for the Calibrator.
Note
The Calibrator is referred to as the UUT (unit under test) in the calibration
procedures in this Chapter.
Temperature Source Calibration
Figure 4-1 shows a flow chart of the calibration procedure.
Note
For assistance with the calibration process, contact an Authorized Service
Center. See “How to Contact Fluke Calibration” in Chapter 1.
This procedure is to be considered a general guideline. Each laboratory
should write their own procedure based on their equipment and their
quality program. Each procedure should be accompanied by an uncertainty
analysis also based on the laboratory’s equipment and environment.
To Next Page
Loading...
