9190A
Operators Manual
2-4
Display and Control Panel
Table 2-2 shows and describes the function of each button on the Control Panel.
Table 2-2. Display and Control Panel
9190A
1
9
2
3
4 5
67
8
gzs002.eps
Item Name Function
Display
Shows block temperature, measurements, status information, operating
parameters, and softkey functions. The contrast of the display is adjustable.
To adjust the contrast, push ▲ to increase contrast or ▼ to decrease
contrast while the Main screen is shown.
Arrow Keys
▲▼◄►
Navigates through menu selections, increases or decreases numbers, and
scrolls menus up or down.
Enter Key
Selects menus and sets new values.
SET Point Key
Set a SETPOINT temperature to heat or cool to.
°C/°F Key
Switches the displayed temperature units between °C and °F. Key is
enabled only when the Main screen is shown.
Note
This key is disabled in some regions of the world.
Menu Key
Opens the Main menu. See “Menus and Menu Navigation” on page 2-10 for
information on each menu and the settings found in the menus.
Exit Key
Cancels all changes and navigates back to the previous menu.
Softkeys
Navigates the menus on the display. The functions of the softkeys are
shown on the display above the buttons.
Block Temperature
Indicator
Visual safety indicator that illuminates when the block temperature is unsafe
and extinguishes when the block temperature is safe. If the block
temperature is unsafe and the Calibrator is turned off or the mains power
cord is disconnected, the indicator flashes until the block temperature cools
to a safe temperature. Do not transport or remove Inserts until the indicator
is off.
Warning
For safe operation and maintenance of the product, do not
remove Inserts when the Block Temperature indicator is
illuminated.
To Next Page
Loading...
