Fluke 9190A - Power and Remote Interface Panel; Startup and Main Screen

9190A
Operators Manual
2-6
Power and Remote Interface Panel
Table 2-4 shows and describes the connectors and ports on the Power and Remote
Interface Panel.
Table 2-4. Power and Remote Interface Panel
3
4
5
1
2
gzs004.eps
Item Name Function

Mains Power Cord
Receptacle
Receptacle for the mains power cord. Use an AC mains supply
appropriate for the voltage range and region of use.
 Power Switch Turn on (I) and turn off (O) the Calibrator.

9-pin Subminiature
Serial Connector (RS-232)
Transmits measurements and remotely controls the operation of
the instrument. See Chapter 3, “Remote Operation”.
 USB Serial Connector
Transmits measurements and remotely controls the operation of
the instrument. See Chapter 3, “Remote Operation”.
 Fuse Product fuse. See Chapter 4 for fuse replacement instructions.
Startup and Main Screen
When the Calibrator turns on, the system initializes, does a self-check, then shows a
startup screen that shows the model number and firmware version information. If the self-
check finds an error, the error is shown on the Startup screen. Contact Fluke Calibration
if an error shows on the Startup screen.
After the start-up initialization is complete, the Startup screen disappears and the Main
screen shows on the display. Table 2-4 shows and describes the indicators on the Main
screen.