Fluke AIRCHECK - Page 38

AirCheck Wi-Fi Tester
Users Manual
30
• All 802.11 settings (For example, Enable 2.4 GHz band
and Enable 5 GHz band. See page 38.)
• Country
• AutoTest settings
• Threshold settings for bar graphs
If you save the profile while you use it on the tester, the
tester adds these settings to the profile:
• The sound setting for the locate function
• The auto shutoff setting
• Sequences for the sort order for lists of networks,
access points, and clients
To transfer a profile from a PC to the tester
1 Use the Profile Setup in AirCheck Manager to make a
profile.
2 Use the USB cable supplied with the tester to connect
the tester to the PC.
3 Use the transfer function in the Profile Setup to
transfer the profile to the tester.
To load a profile that is in the tester
1 From the home screen, press  Profiles.
2 Highlight and press L Load profile.
3 Highlight a profile and then press  Load
Or
1 Select Tools > Manage profiles / network passwords,
then select Load profile.
2 Highlight a profile, press L, then press  Load.
Note
If the file is not a valid profile, or if the extension is
not “.ACP”, the tester shows the message “Unable
to load selected profile”.
3 Enter the password for the profile, if necessary.
Note
You only need to enter the password the first time
you load a profile on the tester. To put password
protection on all profiles again, select Tools >
Restore factory defaults.