Endurance® Series
Users Manual
26
The Object/Target Temperature Display fulfills two tasks to inform the operator:
• In normal operation after warm up phase, it displays the current measured object
temperature, including any signal processing like “Averaging Hold”, “Peak Hold” or
“Valley Hold”. The displayed temperature depends on the preset measurement unit
(°C or °F), done in the “CONFIGURATION MENU” and described hereafter.
• In abnormal operation, during warm up phase or in failure case, discovered through
the failsafe-circuit, it displays an error code (e.g. ECHH, ECUU, EUUU, EAAA…).
Please see section 11.2, Fail-Safe Operation, on page 89.
6.1.2. The Screen / Menu Display
Figure 17: Lower Screen / Menu Display
The Screen/Menu Display is the central user interface display, which shows all selected menus,
their submenus and parameters. In dependence of the selected main menu item, it displays the
first submenu item as default. The menu, sub-menu and entry selection will be done by specific
buttons, described herein afterwards.
6.1.3. The LASER / LED / CAMERA Indicator LED (red)
Figure 18: Upper LASER / LED /CAMERA Activation LED (red)
Indicates the activation (switched-on state) of the integrated LASER, LED or CAMERA.
6.1.4. The Status Indicator LED (green)
Figure 19: Lower Status Indicator LED (green)
Shows a steady green after warm up period to indicate an error free function of the Endurance
device.
6.1.5. The 4 Control Panel Pushbuttons
6.1.5.1. The Browser Button
The Browser Button serves as a selector for one of the five submenus. A
specific submenu selection can be done in the following ways:
• Pressing the Browser Button several times in series to toggle between the
5 submenus
• Holding the Browser Button pressed, toggles between the 5 submenus
about every 2 sec
Stop to press the Browser Button, if you’ve reached the preferred submenu, displayed on the
Screen/Menu display. The first menu entry of the selected submenu will be displayed as default.
To Next Page
Loading...
