Device Control
The control panel menu structure and their associated entries
27
6.1.5.2. The ENTER Button
The Enter Button confirms the selection of a submenu or a specific submenu
entry. After walking through the listed submenu entries by using the Navigate
Buttons, the selection done by the Enter Button initiates a blinking of the
modifiable entry, displayed in the 2nd row of the Screen/Menu display. To store
updated entries a final press of the Enter Button is needed. With the Enter
Button you also walk through multiple section entries, like network IP-
addresses (4 subfields with a value range of 0-255).
6.1.5.3. The Navigate Up Button
The Navigate Up Button enables you to walk through the list of integrated
entries per submenu, increases marked numerical values or toggles the
specific entry.
6.1.5.4. The Navigate Down Button
The Navigate Down Button enables you to walk through the list of integrated
entries per submenu, decreases marked numerical values or toggles the
specific entry.
6.2. The control panel menu structure and their associated entries
There are five (5) submenus available via the control panel:
• INFORMATION MENU (delivers condensed Endurance device information)
• CONFIGURATION MENU (display and alteration of configuration settings)
• UNIT SETUP MENU (display and alteration of device setups)
• INTERFACE MENU (display and alteration of integrated interface setups)
• ANALOG MENU (display and alteration of integrated current loop Analog-I/O)
To Next Page
Loading...
