Innovative High Temperature Infrared Pyrometers
Safety Instructions
1
1. Safety Instructions
This document contains important information, which should be kept at all times with the
instrument during its operational life. Other users of this instrument should be given these
instructions with the instrument. Eventual updates to this information must be added to the
original document. The instrument can only be operated by trained personnel in accordance
with these instructions and local safety regulations.
Acceptable Operation
This instrument is intended only for the measurement of temperature. The instrument is
appropriate for continuous use. The instrument operates reliably in demanding conditions, such
as in high environmental temperatures, as long as the documented technical specifications for
all instrument components are adhered to. Compliance with the operating instructions is
necessary to ensure the expected results.
Unacceptable Operation
The instrument should not be used for medical diagnosis.
Replacement Parts and Accessories
Use only original parts and accessories approved by the manufacturer. The use of other
products can compromise the operation safety and functionality of the instrument.
Instrument Disposal
Disposal of old instruments should be handled according to professional and
environmental regulations as electronic waste.
Operating Instructions
The following symbols are used to highlight essential safety information in the operation
instructions:
Helpful information regarding the optimal use of the instrument.
Warnings concerning operation to avoid instrument damage and personal injury.
The instrument can be equipped with a Class 2 laser. Class 2 lasers shine only
within the visible spectrum at an intensity of 1 mW. Looking directly into the laser
beam can produce a slight, temporary blinding effect, but does not result in physical
injury or damage to the eyes, even when the beam is magnified by optical aids. At
any rate, closing the eye lids is encouraged when eye contact is made with the laser
beam. Pay attention to possible reflections of the laser beam. The laser functions
only to locate and mark surface measurement targets. Do not aim the laser at
people or animals.
Pay particular attention to the following safety instructions.
Use in 115/230 V~ electrical systems can result in electrical hazards and personal
injury, if not properly protected. All instrument parts supplied by electricity must be
covered to prevent physical contact and other hazards at all times.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
