Endurance® Series
Users Manual
30
Order of subentry appearance:
1. Subentry: CONDENSED INFO FIELD
The content for 1C Endurance sensor types (E1M, E2M, E3M) or 1C-mode of ratio
sensor types (E1R, E2R) varies regading the signal processing setup.
The content for E1M, E2M, E3M and E1R, E2R sensor types in 1C-mode is as follows:
a.) Mode: 1-Color (fix for E1M, E2M, E3M) or configuration setup for E1R, E2R
b.) Internal Temperature: Displayed in °C or °F as set in configuration setup menu
c.) Emissivity: As preset in unit setup menu
d.) Average, Peak Hold or Valley Hold time: As preset in unit setup menu
The content for ratio sensor types (E1R, E2R) in 2C-mode is as follows:
a.) Mode: 2-Color as set in configuration setup menu for E1R, E2R
b.) Internal Temperature: Displayed in °C or °F as set in configuration setup menu
c.) Slope: As preset in unit setup menu
d.) Attenuation: Measured attenuation value by the Endurance ratio device
2. Subentry: INTERNAL TEMP.
Displays the internal device temperature in °C or °F (e.g. 39.8 °C)
3. Subentry: ATTENUATION
The subentry is just available and visible on ratio (E1R, E2R) devices. A percentage
value of the measured attenuation will be displayed (e.g. 100%)
4. Subentry: LOW LIMIT
Displays the low limit temperature of the measurement range in °C/°F (e.g. 400.0 °C)
5. Subentry: HIGH LIMIT
Displays the high limit temperature of the measurement range in °C/°F (e.g. 1800.0 °C)
6. Subentry: SENSOR IDENT
Displays the Endurance sensor identification number, where the sensor model, the
focus, the sighting, the cooling and communication options are integrated. (e.g. E1RL-
F2-D-0-0)
7. Subentry: SENSOR REVISION
Displays the Endurance sensor firmware revision number (e.g. 2.02.08)
8. Subentry: SERIAL NUMBER
Displays the Endurance sensor serial number (e.g. 31760001)
9. Subentry: MAC ADDRESS
Displays the unique assigned Endurance sensor MAC address for network
communication via Ethernet / Profinet (e.g. 001d8d200001)
To Next Page
Loading...
